IDEAL Networks NaviTEK NT - Cable Tests Details; Wiremap Setup Options; Wiremap Test Results

NaviTEK NT 153800 Iss 1
User Guide Page 24
Cable Tests
Wiremap
Setup
Cable Type – Cat3 UTP
- Cat3 STP
- Cat5 UTP
- Cat5 STP
- Cat5e UTP
- Cat5e STP
- Cat6 UTP
- Cat6 STP
- Cat7
- USOC
- ETH S1236
- ETH S1278
- ETH U1236
- ETH U1278
- IND. M12
- COAX RJ59
Colour Scheme - None
- 568A
- 568B
- USOC
- TERA
Crossover Allowed – Yes
- No
NVP – Fixed 72%
- Custom 59% - 89%
Termination Type
None - Open
Active Remote - #1 - #12
Tests (No Termination)
Faults – Open circuit by pair
- Short circuit by pin
Length of pair – Metres / Feet (Set in System Setup)
- Range 100m / 330ft
Tests (Active Remote Termination)
I/D – Remote #
Indications on Remote – Voltage Warning (>±10volts on any pins)
- Pass/Fail
Faults – Open circuit by pin
- Short circuit by pin
- Crossed pairs
- Split pairs
- Bridged shorts
- Remote shorts
Length of pair – Metres / Feet (Set in System Setup)
- Range 100m / 330ft
Tone Generator
Setup
Tones – 3
Wire I/D – Tone applied to one of 8 pins relative to the other 7
- Tone applied across one of 4 pairs
Test
Audible tone detected using compatible tone probe