Page 14
4. Remove the defective fuse by gently prying one end of the fuse loose and sliding the
fuse out of the fuse holder.
5. Install a new fuse of the same size and rating. Make sure it is centered in the fuse holder.
6. Make sure the battery box leads do not become pinched between the case and
battery cover before replacing the bottom case and battery cover.
Cleaning
Warning
To avoid electrical shock or damage to the meter, never allow water inside the case.
To avoid damaging the meter’s housing, never apply solvents to the meter.
Performance Test
Testing the Display
Turn the meter on while holding down the [HOLD] key for 2 sec to activate the Display Test Mode on the
meter. To De-activate the Display Test Mode turn meter off and back on.
Compare the display with the appropriate example in the figure below.
Form number TM61480-1-2 Rev 5 July 2002
To Next Page
Loading...
