53
Remote operation
iDECT Loop Plus system
1. Using a tone-dialling phone, dial your home number
2. While your outgoing message is playing, press < * >
3. Key in your remote security code
The default code is 0000. For details of how to set a new code, see the User Guide 8.5.9.2 on
page 52.
Note: The <*> key must be entered while the OGM is still playing, and the 4-digit
PIN should follow without any delays.. If the 4-digit Remote Access
PIN is entered incorrectly three times consecutively, the line will be released automatically.
4. If the security code is accepted, use the codes on the other side of this card for remote operations.
Note: If your answering machine is switched off, the phone will enter into the remote access mode
after 14 rings.
You can then enter the 4-digit remote access PIN
(Default Remote Access PIN is 0000) to activate the remote access feature.
To Next Page
Loading...
