iDect Loop Plus Twin - Remote Access PIN and Compression Rate

52
8.5.9.2 Change the 4-Digit Remote Access PIN
1. Press
M
and
.
to select ANS. MACHINE.
2. Press
M
and
.
to select TAM SETTINGS.
3. Press
M
and
.
to select CHANGE PIN.
4. Press
M
to enter the old PIN (default remode access PIN is 0000).
5. Press
M
to enter the new PIN.
6. Press
M
to conrm.
NOTE
If the new PIN entered in Step 6 is not matched with the new system PIN
entered in Step 5, user is requested to enter the valid system PIN again in
Step 5.
8.5.10. Change the Compression Rate
Three dierent compression rates (HIGH, MID and LOW) are provided for
you to select dierent quality levels of recording incoming message. The
lower the compression rate, the higher the recording quality level aained,
but the shorter the total recording me available.
1. Press
M
and
.
to select ANS. MACHINE.
2. Press
M
and
.
to select TAM SETTINGS.
3. Press
M
and
.
to select COMPRESSION.
4. Press
M
and
.
to select HIGH, MID or LOW.
5. Press
M
to conrm.