Idemia MorphoWave Compact - Access Control Modes

IDEMIA DOCUMENT – REPRODUCTION AND DISCLOSURE PROHIBITED
The terminal can be configured in one of the modes described in the table below
Access Control Modes
8
Identification
Authentication
Multifactor
Proxy
Access
control
a
pplication
Application that runs
on the terminal when
it starts.
Application that runs
on the terminal when
it starts.
Application that runs
on the terminal when
it starts.
Remote application
that controls the
terminal through
network commands
Access
control
triggering
event
A user swipes his/her
hand in the biometric
sensor.
A user places
a
contactless
card in
front of
the reader.
(*)
Both
Identification
and Authentication
triggers are enabled.
Triggering events are
selected
by the
remote application
Biometric
check (if
enabled)
The user’s captured
fingerprints are
matched against all
fingerprints in the
terminal database.
The user’s captured
fingerprints
are
matched against
their reference
fingerprints.
(**)
As per Identification
or Authentication,
depending on the
triggering event
Selected
by the
remote application
Decision
to
display
result
signal to user
By Identification
standalone
application or
controller feedback
By Authentication
standalone
application or
controller feedback
By
running
s
tandalone
application or
controller
feedback
By remote
application
(* )
or the user enter their Identifier on the keypad, or a Wiegand frame is received from an external device
(**)
stored on the contactless card or in the user record in the terminal’s local database
Step one : overview
IDEMIA - 2018_2000035854 – V1