Adding a Maid’s Code
A maid’s code is a code that can only disarm the alarm if it has been used to arm the alarm. If a general
user code has been used to arm, the maids code will not be able to disarm.
[*] [master code] [*] [1] [4] [*] [code] [*]
1. Press and hold [*] key for 3 seconds
2. Enter master code. [1] [2] [3] [4] [*]
3. User number. [1] [4] [*]
4. User code. [4] [4] [3] [2] [*]
Adding a Duress Code
A duress code is a code that will disarm the alarm and activate a panic condition when used. If system is
connected to an armed response centre a duress code will be sent indicating that someone is being
forced to disarm the system.
[*] [master code] [*] [1] [5] [*] [code] [*]
1. Press and hold [*] key for 3 seconds
2. Enter master code. [1] [2] [3] [4] [*]
3. User number. [1] [5] [*]
4. User code. [2] [5] [8] [0] [*]
To Next Page
Loading...
Need help?
General
