IFM Electronic DA102S - Internal Faults; 10 Maintenance, Repair and Disposal

20
9.1.3 Internal faults
Status Power Fault K1, K2 E1, E2 Outputs
13-14, 23-24
Transistor
Y7
Device-internal error
OFF LOW
A flash code is output via the "Power" LED.
This flash code enables the manufacturer to analyse the device-internal error.
► If the error message is not reset in spite of the interruption of the supply
voltage,exchangethedevice(→4.1.2Product-dependentrequirements).
10 Maintenance, repair and disposal
If used correctly, no maintenance and repair measures are necessary.
► Observetheproduct-dependentrequirements(→4.1.1).
► Check the safe functioning of the unit after a fault.
Only the manufacturer is allowed to repair the unit.
After use dispose of the unit in an environmentally friendly way in accordance with
the applicable national regulations.