EasyManua.ls Logo

IFM CompactModule CR2032 - Maintenance, Repair and Disposal; Declaration of Conformity; Terms and Abbreviations

IFM CompactModule CR2032
29 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
UK
CompactModul Metall CR2032
27
12 Maintenance, repair and disposal
As the module does not contain any components which must be maintained by the
user, the housing must not be opened�
The maintenance of the module may only be carried out by the manufacturer
The disposal must be carried out according to the corresponding national envi-
ronmental regulations�
13 Declaration of conformity
For test standards and regulations → 9 Technical data
The CE Declaration of Conformity and the E1-approval are available at:
www�ifm�com�
14 Terms and abbreviations
0b ��� binary value (for bit coding), e�g� 0b0001 0000
0d ��� decimal numerical value, e�g� 0d100
0x ��� hexadecimal value, e�g� 0x64 (= 100 decimal)
Baudrate transmission speed (1 baud = 1 bit/s)
CAL CAN Application Layer
CAN-based network protocol on application level
CAN Controller Area Network (bus system for use in mobile applications)
CAN_H CAN-High; CAN connection /cable with high voltage level
CAN_L CAN-Low; CAN connection /cable with low voltage level
CANopen CAN-based network protocol on application level with an open configuration interface
(object directory)
CiA "CAN in Automation e�V�"
(user and manufacturer organisation in Germany/Erlangen)
Definition and control body for CAN and CAN-based network protocols
CiA DS Draft Standard (published CiA specification which usually has not been modified or supple-
mented for one year)
CiA DSP Draft Standard Proposal (published CiA specification draft)
CiA WD Work Draft (work draft accepted for discussion within CiA)
CiA DS 301 Specification for CANopen communication profile;
describes the basic communication between network participants, such as the transfer of
process data in real time, the exchange of data between units or the configuration stage�
Depending on the application this is completed by the following CiA specifications:
CiA DS 401 Device profile for digital and analogue I/O modules
CiA DS 402 Device profile for drives
CiA DS 403 Device profile for HMI
CiA DS 404 Device profile for measurement and control technology
CiA DS 405 Specification for interfaces to programmable systems (IEC 61131-3)
CiA DS 406 Device profile for encoders
CiA DS 407 Application profile for local public transport

Related product manuals