IFM Ecomat 300 AC1421 - Page 55

55
ifm Device Manual SmartSPS AC14 with EtherNet/IP interface (AC1421, AC1422), Firmware 3.1.2 2015-11-30
Menu Quick setup
>
5.2.9 Quick setup: Address the AS-i slaves connected to AS-i master 2
11671
To change the address of an AS-i slave connected to AS-i master 2
1 Select the menu page
►
► Select [Addressing AS-i 2] tab.
2 Change the AS-i slave address
The procedure for addressing the AS-i slaves connected to AS-i master 2 is the same as for addressing the AS-i slaves
connected to AS-i master 1 (→ Quick setup: address the AS-i slaves connected to AS-i master 1 (→ page 54)).