IFM Ecomat 300 AC1421 - Page 57

57
ifm Device Manual SmartSPS AC14 with EtherNet/IP interface (AC1421, AC1422), Firmware 3.1.2 2015-11-30
Menu AS-i 1 / AS-i 2
>
5.3.1 AS-i 1 / AS-i 2: Master setup
8996
The menu item [Master setup] provides access to the configuration options of the selected AS-i
master.
>
Set the operating mode of the AS-i master
15877
More information on the operating modes of the AS-i master: → Operating modes of the AS-i
master (→ page 137)
To set the operating mode of the AS-i master:
1 Select the menu page
► > or >
2 Set the operating mode of AS-i master 1 and the behaviour of the connected AS-i slaves
> Set the following parameters as required:
Parameter
Meaning
Possible values
[Projection mode]
Active operating mode of the
AS-i master
=
Projection mode inactive:
AS-i network operates in protected mode
(normal mode)
=
Projection mode active:
AS-i network can be projected.
[No slave reset]
Behaviour of the AS-i slaves
when changing the operating
mode
=
Slave is reset when changing the operating
mode:
When changing the operating mode, the
AS-i slaves will be reset for a short moment
(reset or offline phase).
=
Slave is not reset when changing the operating
mode:
When changing the operating mode, the
AS-i slaves continue to operate without
interruption.
> Selected values are applied.