IFM Efector 180 IX5030 - 2�1 Permissible Shapes and Dimensions of the Target; 2�2 Non-Permissible Shapes and Dimensions of the Target

5
UK
The valve spindle to be measured must have the following characteristics:
• Diameter 24 mm (tolerance: ± 0�05 mm), height at least 10 mm
• The end surface must be flat
• Material: stainless steel to DIN 17440, material number 316L / 1�4404
2.1 Permissible shapes and dimensions of the target
Ø24mm
10mm
Ø24mm
10mm
10mm
Ø24mm Ø24mm
15mm
2.2 Non-permissible shapes and dimensions of the target
Ø24mm
5mm
Ø24mm
10mm
Ø24mm
10mm
Ø18mm
10mm