Need help?Do you have a question about the IFM efector 160 LR3000 and is the answer not in the manual?
General| Brand | IFM |
|---|---|
| Model | efector 160 LR3000 |
| Category | Accessories |
| Language | English |
Explains various symbols used throughout the manual for clarity.
Critical safety information for proper installation and operation of the unit.
Details operation with single rod and coaxial probes for level measurement.
Explains guided wave radar technology and key unit capabilities.
Describes the analogue output signal and its graphical representation.
Configuration options for switching outputs like hysteresis and window.
Setting offsets, probe fitting, and safe state configurations.
Guidelines for installation location and setup with a single probe.
Step-by-step guide for installing coaxial probes and rods.
Procedures for shortening the probe rod and coaxial pipe.
Specific instructions for installing the unit in metal tanks.
Guidelines for installing in plastic tanks and using flange plates.
Visual representation of the parameter menu hierarchy.
Step-by-step guide for modifying parameter values.
Configuring probe length, medium, and probe type on delivery.
Setting display units, offset values, and OUT1 output function.
Configuring switching limits for hysteresis and window modes.
Scaling analogue output and defining fault responses.
Restoring factory defaults and modifying basic settings.
Understanding operating indicators and reading set parameters.
Identifying errors and changing display units during operation.
Details technical data including operating ranges and limits.
To Next Page
