1 - Introduction
8
StealthPedal
™
CS
1.3 How to Use StealthPedal Safely
• Avoid using the StealthPedal in the following locations to prevent
possible damage: in extremely cold or hot locations or locations
exposed to high humidity or excessive dust.
• Do not apply excessive force to jacks, switches and volume knob.
• Care should be taken that objects do not fall on the enclosure and
liquids are not spilled into the enclosure.
• Never open the case and tamper with the internal circuits. No service-
able parts inside.
• Always use a dry, soft cloth to wipe off dust and dirt. Never use liquids
or chemicals for cleaning.
• When the StealthPedal is not being used, disconnect and store it in
a safe place.
1.4 Electromagnetic Compatibility
For EU Countries
This product complies with the requirements of the European Electromagnetic
Compatibility (EMC) Directive 2004/108/EC.
For the USA
FEDERAL COMMUNICATIONS COMMISSION RADIO FREQUENCY
INTERFERENCE STATEMENT
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particu-
lar installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including inter-
ference that may cause undesired operation.
Unauthorized changes or modification to this system can void the user’s
To Next Page
Loading...
Need help?
General
