2 - Getting started
16
StealthPedal
™
CS
2.2 StealthPedal Software Installation Introduction
StealthPedal system is a Hardware/Software combination. In order to use
StealthPedal either live or in the studio you will need a Mac or PC computer
(check Installation and Authorization manual for system requirements).
You need to install on your computer all software included with StealthPedal
to get the best possible user experience. There are three main software com-
ponents you need to install first to properly operate StealthPedal:
• AmpliTube Software
• StealthPedal System Drivers (will be automatically installed during
the AmpliTube Software installation process)
• StealthPedal MIDI Control Application (refer to the StealthPedal
MIDI Control User Manual)
2.3 AmpliTube and StealthPedal System Drivers Installation
To properly install the StealthPedal, please do not connect the StealthPedal unit
to the computer until after following these few steps:
IMPORTANT: NEVER CONNECT THE STEALTHPEDAL TO AN INTERNAL OR
EXTERNAL USB HUB. PLEASE ENSURE YOU ARE CONNECTING STEALTHPEDAL
TO A DIRECT USB PORT ON YOUR COMPUTER (as an example on most desktop
PCs you will need to use the USB ports on the back of the machine, not on the
front as these are most probably connected to an internal hub).
For further reference on AmpliTube installation, please refer to Installation
and Authorization manual.
Windows®:
1. DO NOT connect the StealthPedal to the computer yet.
2. Insert the Installer CD into your computer drive.
3. Double click the file named ‘Install AmpliTube’ to install, register
and authorize the AmpliTube software and the necessary driver.
Follow the on-screen steps, and connect StealthPedal to an avail-
able USB port after the installation process has finished.
4. Double click the file named ‘Install StealthPedal MIDI Control’ to
install the StealthPedal MIDI Control software.
5. Load AmpliTube from: Start/Programs/IK Multimedia/AmpliTube.
6. Once loaded, click Settings > Audio Setup. Select ASIO and set Input
and Output to StealthPedal.
Once the installation finishes you can connect your StealthPedal to your
computer using the included USB cable (figure 2.2).
To Next Page
Loading...
Need help?
General
