FAULT CAUSE TROUBLESHOOTING
E:07 lights up.
Intake opening is covered by items
of tableware.
● Re-arrange the tableware in the appliance so the “intake opening”
→ Page 17 is no longer obstructed.
E:12 lights up.
Appliance has detected calcified
heating element.
1. Descale the appliance.
2. Operate the appliance with the Water softening system.
E:14 lights up.
Water protection system is
activated.
1. Turn off the water tap.
2. Call Customer Service.
E:15 lights up.
Water protection system is
activated.
1. Turn off the water tap.
2. Call Customer Service.
E:16 lights up.
Water is continuously running into
the appliance.
1. Turn off the water tap.
2. Call Customer Service.
E:18 or indicator for water
supply lights up.
Supply hose is kinked. ● Install the supply hose without kinks.
Water tap is turned off. ● Turn on the water tap.
Water tap is jammed or furred up.
● Turn on the water tap.
The flow rate must be at least 10 l/min when the water supply is open.
Filter in the water supply is
blocked.
1. Switch off the appliance.
2. Pull out the mains plug.
3. Turn off the water tap.
FAULT CAUSE TROUBLESHOOTING
E:27 lights up. Mains voltage is too low.
This is not a fault on the appliance.
1. Contact an electrician.
2. Have the mains voltage and electrical installation checked by an electrician.
Another error code appears on the display. E:01 to E:30 A technical fault is present.
1. Press .
2. Unplug the appliance or switch off the fuse.
3. Wait at least 2 minutes.
4. Insert the mains plug of the appliance in a socket or switch on the fuse.
5. Switch the appliance on.
6. If the problem occurs again:
Press .
Turn off the water tap.
Pull out the mains plug.
Contact Customer Service and give the error code.
Washing results
To Next Page
Loading...
Need help?
General
