FAULT CAUSE TROUBLESHOOTING
Tableware is not
dry.
No rinse aid used or dosage set too low.
1. Add “Rinse aid” → Page 31.
2. Set the amount of rinse aid to be dispensed.
Programme or programme option has no drying phase, or the drying
phase is too brief.
● Select a programme with
drying, e.g. intensive, strong or ECO programme.
Some option buttons decrease the drying result, e.g
varioSpeed.
Water collects in recesses of the tableware or cutlery. ● Position tableware at an angle where possible.
FAULT CAUSE TROUBLESHOOTING
Tableware is not dry.
The combined detergent used has a poor drying performance.
1. Use rinse aid to improve drying performance.
2. Use a different combined detergent with a better drying
performance.
Extra Dry not activated to improve drying performance. ● Activate Extra Dry.
Tableware removed
too early or drying process not yet ended.
1. Wait until the programme ends.
2. Only remove tableware 30 minutes after the programme
has ended.
Rinse aid used has a limited drying performance.
● Use a name-brand rinse aid. Eco products may have limited
effectiveness.
Plastic tableware is
not dry.
Not a fault. As plastic does not store heat so well, it also does
not dry as well.
● No remedial action possible.
Cutlery is not dry.
Cutlery not arranged properly in the cutlery basket or cutlery
drawer.
Droplets can form on the cutlery contact points.
1. “Arrange cutlery individually where possible.” → Page 36
2. Avoid points of contact.
To Next Page
Loading...
Need help?
General
