IKEA DISKAD User Manual

FAULT CAUSE TROUBLESHOOTING
Appliance interior
still wet after wash
cycle.
Not a fault. The condensation drying principle causes water droplets in the tub – they are
indeed desirable here. The moisture in the air condenses on the inside walls, runs off and
is pumped out.
No action required.
Remnants of food
on tableware.
Tableware is placed too close together or basket is overfilled.
1. Arrange tableware with
sufficient space in between.
The spray jets must reach the
surfaces of the tableware.
2. Avoid points of contact.
Spray arm rotation is blocked.
● Arrange tableware so that it
does not obstruct spray arm
rotation.
Spray arm nozzles are blocked.
● Clean the “Spray arms”
→ Page 44.
Filters are soiled.
● Clean the filters.
→ “Cleaning filters”, Page 44
Filters are inserted incorrectly and/or not engaged.
1. Insert the filters properly.
→ “Filter system”, Page 43
2. Engage the filters.
Washing programme selected too weak.
Select a more intensive
washing programme.
Adjust the sensitivity of the
sensors.
→ “Sensors”, Page 14
Tableware has been precleaned too intensely. The sensors chose a weaker programme.
Stubborn soiling cannot be entirely removed.
Only remove large remnants
of food and do not prerinse
tableware.
Adjust the sensitivity of the
sensors.
→ “Sensors”, Page 14

IKEA DISKAD Specifications

General

Type	Built-In
Number of Place Settings	13
Noise Level	44 dB
Voltage	220-240V
Dimensions	60 x 82 x 55 cm