IKEA DISKAD - Rinse Aid System; Adding Rinse Aid; Setting Rinse Aid Amount

Water is left in the appliance at the
end of the programme.
Filter system or area under the filters is blocked.
1. Clean the “Filters” → Page 44.
2. Clean the “Wastewater pump” → Page
59.
Information on display panel
FAULT CAUSE TROUBLESHOOTING
Special salt refill indicator lights up.
Insufficient special salt. ● Add “Special salt” → Page 29.
Sensor does not detect special salt
tablets.
● Do not use special salt tablets.
Refill indicator for special salt does not light
up.
Water softening system is switched off. ● “Setting water softening system” → Page 29
Refill indicator for rinse aid lights up. Insufficient rinse aid.
1. Add “Rinse aid” → Page 31.
2. Set the amount of rinse aid to be
dispensed.
Refill indicator for rinse aid does not light up. Rinse aid system is switched off.
● Set the amount of rinse aid to be dispensed.
→ “Setting the amount of rinse aid”, Page 32
→ “Setting the amount of rinse aid”, Page 32
Malfunctions