IKEA DISKAD User Manual

FAULT CAUSE TROUBLESHOOTING
Water is left in the
appliance at the end of the
programme.
Programme has not yet ended.
Wait until the programme ends or cancel the
programme with reset.
→ “Terminate programme”, Page 38
Appliance cannot be
switched on or operated.
Appliance functions have failed.
1. Pull out the mains plug or switch off the fuse.
2. Wait at least 2 minutes.
3. Connect the appliance to the power supply.
4. Switch the appliance on.
Appliance does not start.
The mains fuse has tripped. ● Check the relevant fuse.
Mains cable is not inserted.
1. Check whether the socket works.
2. Check whether the mains cable is properly inserted in
the socket and on the rear of the appliance.
Appliance door is not closed properly. ● Close the appliance door.
Programme starts
automatically.
You did not wait until programme ended. ● → “Terminate programme”, Page 38
Appliance stops during the
programme or cuts out.
Appliance door is not closed properly. ● Close the appliance door.
Power and/or water supply has been
interrupted.
1. Check the power supply.
2. Check the water supply.
Top basket is pressing against inner door and
preventing appliance door from being closed
securely.
Check whether the rear panel of the appliance is being
pressed in by a socket or hose holder that has not been
removed.
Arrange the tableware so that no parts project beyond
the basket and prevent the appliance door from closing
properly.
Mechanical damage

IKEA DISKAD Specifications

General

Type	Built-In
Number of Place Settings	13
Noise Level	44 dB
Voltage	220-240V
Dimensions	60 x 82 x 55 cm