FAULT CAUSE TROUBLESHOOTING
Appliance door cannot
be closed.
Door lock has been activated. ● Close the appliance door with greater force.
Door cannot be closed due to
installation method.
● Check whether the appliance has been installed properly. When closed, the
appliance door, its decor or attached parts should not knock against adjacent
cabinets or the worktop.
Lid on the detergent
dispenser cannot be
closed.
Detergent dispenser or lid are
blocked by sticky detergent
residue.
● Remove detergent residue.
Noise
FAULT CAUSE TROUBLESHOOTING
Filling valves making knocking
noises.
Caused by the domestic installation. No appliance fault present. Does not affect functioning
of the appliance.
● Can only be remedied in the domestic installation.
Knocking or rattling noise.
Spray arm is striking tableware.
● Arrange tableware so that the spray arms do not strike
tableware.
With a small load the water jets directly strike against the tub.
Distribute the tableware evenly.
Load the appliance with more tableware.
Light items of tableware move about during the wash cycle. ● Position light items of tableware securely.
Clean wastewater pump
Large remnants of food or foreign bodies can block the waste water pump. As soon as the rinsing water no longer drains properly, the waste water pump must be cleaned.
WARNING Risk of injury!
Sharp and pointed objects or fragments of glass may block the waste water pump and cause injury.
● Remove any foreign bodies carefully.
1. Disconnect the appliance from the power supply.
2. Remove the top and bottom basket.
3. Remove the filter system.
4. Scoop out any water.
Use a sponge if necessary.
5. Prise off the pump cover using a spoon and grip it by the crosspiece.
6. Lift the pump cover inwards at an angle and remove.
7. Remove any remnants of food and foreign bodies in the area of the impeller.
8. Insert the pump cover and press down.
a The pump cover clicks into position.
9. Install the filter system.
10. Insert the top and bottom basket.
To Next Page
Loading...
Need help?
General
