INTRODUCTION AND SPECIFICATIONS
Installation
6 LDX-36000 Series
CHAPTER 1
Obtaining Repair Services
The instrument may at some point need to be returned to the factory for service
whether or not it is under warranty. If the warranty has expired, there will be a
nominal charge for repair and/or calibration. See the section entitled Returning an
Instrument in the Preface for shipping and contact information.
Potentially lethal voltages exist within the LDX-36000 chassis even with the key switch in
the off position. To avoid electric shock, do not perform any maintenance on the
instrument. Qualified service personnel trained in ESD prevention are required. High
voltages are present on and around the printed circuit boards.
To disconnect the AC mains supply, remove the power cord from the instrument. If the
AC mains outlet is not easily accessible after instrument installation, ensure that an
external disconnect switch is provided to remove AC power to the instrument.
There are no user-serviceable parts inside the instrument, excepting any external fuses
in the AC power entry module. Contact ILX Customer Service for information about
servicing the instrument.
Options and Accessories
Options and accessories for the LDX-36000 series of instruments include the
following:
Our goal is to make the best laser diode instrumentation available anywhere. To
achieve this, we need your ideas and comments on ways we can improve our
products. We invite you to contact us at any time with your suggestions.
Table 1.1 Options and Accessories
Description Model Number
125 Amp Output Cable, D-sub
CC-340
50 Amp Output Cable, 6 feet
CC-370
125 Amp Output Cable, 6 feet
CC-390
125 Amp Output Cable, 12 feet
CC-395
Calibrated 10 k Thermistor
TS-510
Uncalibrated 10 k Thermistor
TS-520
To Next Page
Loading...
Need help?
General
