Image Access WideTEK 36CL - Firmware Update and Recovery Adjustments

Perform setup
87
Recovery Procedure 2 - Update Scanner Firmware
Step
Action
11
If the scanner's currently installed firmware is not the latest version,
connect to the scanner using a web browser.
12
Select "Device Setup".
13
Log in to "Poweruser" using "Poweruser" for username and
password.
14
Select "Updates & Uploads".
15
In "Update Scanner Firmware", update the scanner with the
firmware version you previously downloaded from the Customer
Service Portal.
Recovery Procedure 3 - Adjustments
Finally, it may be necessary to make a few adjustments.
Note: All scanners require that you perform at least one new white
balance.
➢ Start with the white balance and perform any additional procedures as
described here in the Setup Guide in the "Performing Setup" chapter.
End of the recovery procedure.