Image Access WideTEK 36CL User Manual

Perform setup
86
Step
Action
5 - All scanners
Recovery starts immediately,
replacing the damaged contents of
the Scan2Net Linux partition with
the contents of the recovery
partition. This process takes about
10 - 15 minutes. At the end, the
scanner automatically shuts down
to standby mode.
6 - All scanners
Wait for the scanner to shut down
to standby mode.
7 - All Scanners
Turn off the scanner via the Main
Power Switch.
8 - Scanner with Recovery Key
Unplug the recovery key from the
connector on the back of the
scanner.
9 - All Scanners
Turn on the scanner via the Main
Power Switch.
10 - All Scanners
Turn on the scanner via the power
button.
This operation will cause all network credentials to be lost.
Important: The default IP address has been reset to the factory
default 192.168.1.50!
➢ To re-establish your original network configuration, please follow
the instructions in the "Assigning IP Addresses" chapter of this
setup guide for your scanner.

Image Access WideTEK 36CL Specifications

General

Brand	Image Access
Model	WideTEK 36CL
Category	Scanner
Language	English