It is not suitable for cutting wood or similar materials ( cfr.D.M. 2006/42/CE ).
It automatically makes a working cycle usually consisting of :
Locking material, approaching and cutting , tool return, unlocking material and its displacement for a new cut.
The operator has to adjust the cutting parameters , to adjust the saw frame swiveling to make the inclined
cuts , to program the strokes quantity , the lenght and the quantity of pieces, and the cycle starting .
In designing and manufacturing this machine, we have considered the requirements of the Machine Directive
(2006/42/ EEC and so on..), important document valid in all E.E.C. Countries. Furthermore we have
considered the norms as type A and B in the case that specifications of type C are not available.
The choice and the use of the parts have been made by considering the conditions of use and the long
machine life.
From the position of the work, in front of the frontal vice, the operator has the possibility to actuate the
controls and to control the good working of the machine.
In the other paragraphs you will find any informations to use the machine in the best way and for a very long
time.
Hereunder described you will find the recapitulation of the informations for the machine marking, its
identification plate is fixed on the right front angle.
The keyboard of the electronic control has a further register number placed on the back shield.
1.1 - APPENDIX FOR E.M.C.
The structure of this machine complies to the protection requirements of the EEC Directives 2004/108/EEC,
2006/95/EEC in terms of Electromagnetic Compatibility (E.M.C.) and LVD.
It especially abides by the technical prescriptions of the norms EN 55011 and EN 50082-2, and it is fit to be
used in industrial environments and not in residential ones.
To Next Page
