that reaches the band and after the rapid approaching start the descent by planning the speed with the
control(8).
At the cutting end the band goes up again and the semiautomatic cycle finishes.If the pushbutton F3 ils
lighing, the saw frame and the blade stops at the end of thew cut.
9.7 - ESC ( Electronic Speed Control - if installed )
As the motor is running, increase or decrease the speed by pushing the button (+/2) - pos.13/RI0055 - or (-/1)
- pos.11/RI0055 – on the display you can read the current speed.
In case the maximum power supply threshold is exceeded - for example, because of an excessive cutting
pressure or because the blade remains stuck into the material - the Inverter stops the motor and the error
message “Er0025” appears on the display. To restore it, the main switch has to be turned to 0 (OFF), wait for
about one minute and then turn it on I (ON).
In the meantime, try to find out the reason that caused the interruption and eliminate it.
9.8 - LOCKING / EMERGENCY LOCKING
It is possible to lock the cycle in any moment :
a - by the button STOP CYCLE-pos.21/dr.RI0055 the machine stops immediately , but there is also the
possibility to use the other controls, for instance to change the cycle type or the blade speed );
b - by the emergency button.. the cycle stops immediately and it is not possible to push other controls before
restoring it.
c - by the main switch -.the energy of the machine is off.
d - by opening the cover blade, a safety stroke end stops the control circuit by causing the movements
locking.
e - in case of electric energy interruption the main sectionalising switch- goes to 0 position and it is
necessary to reset it to start the machine again.
9.9 - HEAD ROTATION FOR OBLIQUE CUTTING
In order to perform cuts between 0° and 60° in automatic cycle unlock the lever placed on the side of the
worktable, manually rotate the sawframe until reaching the required angle on the graduated scale, then lock
again the lever. Easy stops at 0° and 45°.
The cut with automatic feeding has to take place in the cutting range from 0° to 45° left; beyond 45° the vice
can collide with the sawframe. When changing angles there shouldn’t be any materials clamped by the vice
and/or on the worktable.
The sawframe can rotate up to 60° only if:
a) the device for easy stop at 45° is removed
b) the back blade guide is moved backwards all the way (by loosening the screws and positioning it
where the back holes are)
it is highly recommended to reset the blade guide back to the original position when finishing cutting at 60°, in
order to avoid stressing the blade uselessly
-9.10 - AUTOMATIC CUTTING SETTING
In order to carry out an automatic cutting cycle the feeder stroke has to be set. Proceed as follows:
Position the feeder jaw – pos. 1/RI0466 – about 2-3 mm far from the material, and make sure its cylinder is
opened by pushing simultaneously the buttons 4 and 18/RI0055. Lock with the upper handle – pos.2/RI0466.
To Next Page
