Generally: you must empty the cooling installation tank, take out the oil from the reduction box, from the
hydraulic or hydropneumatic installation.
Lock the parts that could move and cause danger or instability.
Remove the parts assigned to the differentiated draining, for example the printed circuit, display
stations, programming keyboards, buffer batteries and so on, especially the ones which shows the picture
..In these cases, in relation with the WEEE/AEEE Regulations, ask to the supplier to know the right
process, that depends by the machine size and purpose.
- SPARE PARTS
The choice of the required spare parts is aided by the included drawings that allow, together with the working
schemes, to know better the machine.
17.1 - NORMS TO REQUEST THE SPARE PARTS
It is necessary to inform the TECHNICAL SERVICE about the following data:
- the serial number indicated on the identification plate
- model, version, type
- voltage and power frequency
- code number of the spare-parts
- requested quality
- eventually the fittings settled later too.
To Next Page
