The maintenance required by this machine is essential to guarantee the continuous correct working over the
course of time and keep the saw in an efficient condition. When you start to use the machine you must do
some extra operations to allow all parts of the machine to settle down to the working conditions.
Please check frequently the working of the machine and avoid to force it to make too many cuts. For a time of
80/100 working hours control the heating of the gear reducer and of the electric motor
Then take away the oil (better if it is warm) by taking out the lower plug placed between the reducer head and
the blade cover and drain it completely. Plug it up again and put into some gas oil for cleaing it inside. Let the
motor idling for some seconds, take out the cleaning gas oil, and put into the new oil, about 2 litres, till
reaching the usual level.
N.B. The presence of bronze or ferrous particles in the replaced oil is normal. The heating of the mechanical
parts (and of the oleodynamic parts for semautomatic / automatic machines) is normal during the usual
working and anyway it does not exceed the foreseen thermic limits.
For the semiautomatic versions control also the oil level in the tank of the hydraulic unit (see parapraph 11).
Control also the oil level in the tank of the hydraulic unit as described in Maintenance for the user).
N.B.. The heating of the mechanical parts (and of the oil-hydraulic parts for semiautomatic saws) is normal
during the usual working and anyway it does not exceed the conventional thermic limits.
Please see the OIL AND LUBRICANTS TABLE in order to choose the most suitable one and to compare the
different types (see drawing RI0108).
20 - DRAINING OF USED / PRODUCED SUBSTANCES
Please remember to abide by the current Law Norms concerning the draining of:
- materials used by the machine (for example hydraulic circuit oil, reduction gear oil, oil for installations of
lubrication and so on);
- scrap materials or materials not usable anymore (for example ferrous and not ferrous chips, tools like
blades and so on);
- substances used for cleaning and maintenance;
- materials used in some instances of the machine life (for example when packing, shipping and so on).
21 - DEFECTS IDENTIFICATION
The solution of most inconvenients that could happen during the working can be found by consulting this
paragraph.
The first part concerns the machine working and includes a list of the possible defects with respective
controls that must be made; the second part concerns the inconvenients that can be found by checking the
blade and / or the cut pieces.
If your problem is not included in the forseen ones or you need the presence of qualified technicians, please
get in touch with the manufacturer or the reseller by keeping in evidence this instruction book .
12.1 - DEFECTS CAUSED BY THE MACHINE
Inconvenients Check
A* The band electric motor does not work 3-4-5-9
B* The hydraulic circuit motor does not work 1-2-3-4-5-9-17
C* The electronical/electric panel does not light on 6-7-8-9
D* No enough pressure in the hydraulic circuit 10-11-12-13
E* The pump of the hydraulic unit is noisy 14-15-16-17
F* The coolant is not sufficient 18-19-20-21
To Next Page
