18
NOTE:
- When the CLOCK SETTING procedure is completed or in
case it is not completed within 10 minutes from start-up,
the chronothermostat will automatically start the “OVERRI-
DE” mode (shown by a blinking “F”, “T1” and the
“hours/temperature” chart on the display), assuring the
working at NORMAL temperature “T1”(“sun” knob) (fig.6).
- The CLOCK SETTING procedure may be start again at
any given time by pressing the reset button (R).
(fig.5)
(fig.6)
LIBR. CRX/E INGLESE 24-01-2000 16:42 Pagina 19
To Next Page
