9. PROGRAM SETTING
Only after the clock is set, the chronothermostat “weekly” pro-
gram may be set, according to the following instructions:
• Press the
D button: the “little triangle” (▲) will blink on the
display, pointing at Monday (day #1) (fig.7).
• Move up the switches (position “
T1 ✲”) for the amount of
hours you want the temperature set with the “sun
✲” knob
(NORMAL temperature). On the contrary, lower the switches
(position “
T2 ”), for the amount of hours you want the REDU-
CED temperature (
T2 button).
• Press
OK to CONFIRM and DISPLAY Monday's setting (fig. 8). If changes are to be made, just set the new settings by
micro-switches and then press
OK to confirm them.
• Press the
D button to switch to the next day: the “little triangle”
(
▲) will blink on the display, pointing at Tuesday (day #2) (fig.
9).The “hours/temperature” chart for Tuesday and for any other
day of the week is set as Monday's.
Once completed the weekly setting, with the “little triangle” (
▲)
blinking and pointing at Sunday (day #7) (fig.10), press the
D
button to immediately end the “PROGRAM SETTING” mode.
19
(fig.7)
(fig.8)
LIBR. CRX/E INGLESE 24-01-2000 16:42 Pagina 20
To Next Page
