Immergas VICTRIX 75 - General Features of VICTRIX 75; Boiler Overview

1
STV75 ed 01/08 VICTRIX 75
VICTRIX 75
Condensing wall-hung open chamber
fan assisted or room-sealed fan-assisted
boiler for central heating only
VICTRIX 75
VICTRIX 75 is a condensing wall-hung open chamber fan assisted
or room-sealed fan assisted boiler for central heating only. With a
special kit (optional) this boiler may be used in conjunction with a
separate boiler unit for the production of domestic hot water with
capacities of 80, 105, 120 and 200 litres.
e boiler is approved for installation both inside a heating station
and outside the building and can be installed single or in cascade by
which we mean the installation of a maximum of 3 boilers in battery
on the same system.
Special hydraulic kits are available as optional accessories to complete
the installation such as the ISPESL safety kit, the distribution
manifold with lter kit, the 3-way diverter valve kit for coupling
the boiler unit storage tank and the hydraulic manifolds kits for
connecting two or three boilers in cascade.
anks to the condensation technology, VICTRIX 75 is distinguished
for its high operating performance and wide modulation range (from
25 % to 100 % of its nominal output).
e boiler has a heat output of 72.6 kW (62.443 kcal/h) and features
an innovative total premix combustion system that ensures minimal
pollution emissions. It can work with natural gas or LPG.
e appliance is regulated and controlled by means of a
microprocessor controlled p.c.b. which, via a display, shows the state
of boiler operation (temperatures, operation status, fault codes, etc.).
General features.
e hydraulic circuit features a water-gas coil exchanger in stainless
steel.
All boilers are tted with an antifreeze device for temperatures of
down to -5 °C.
e VICTRIX 75 boiler must be installed using specic air/ue kits
(green series) made in plastic and especially for the VICTRIX 75
boiler whether it is installed in a single conguration
or in a battery (up to a maximum of 3 boilers).
e plastic (80 mm Ø exible) ducting ue system can also be used,
designed specically for Immergas condensing boilers.
Technical Documentation
Technical Documentation