Safety Precautions Inside front cover
Warranty and Helplines Inside back cover
EMC and LVD Conformity Page 2
1 Inspection, Handling & Storage 2
1.1 Product Enquiries 2
1.2 Inspection 2
1.3 Storage Environment 2
1.4 Storage Precautions 2
1.5 Handling 2
2 Specifications 3
2.1 Output Ratings 3
2.2 Input Ratings 3
2.3 Output Frequency 3
2.4 Braking 3
2.5 General 3
3 Common Specifications 4
3.1 Control 4
3.2 Indication 5
3.3 Protection 5
3.4 Operating Environment 5
4 Mechanical Installation 6
4.1 Handling 6
4.2 Environment 6
4.3 Position and Materials 6
4.4 Cooling and Ventilation 6
4.5 Removable Covers and Keypad 7
4.6 Dimensions 7
5 Electrical Installation 10
5.1 Power Connection Block Diagrams 10
5.2 Power Circuits 11
5.3 Control Circuits 12
5.4 Terminals Functions List 14
5.5 Control Circuits and Terminals 15
6 Keypad Functions 16
6.1 Keypad 16
6.2 Keypad Procedures 16
7 Inverter Functions 21
7.1 Functions Data —Range, Units, 21
Resolution & Default
7.2 Descriptions of Functions 26
8 Troubleshooting 44
8.1 Electronic Protection 44
8.2 Trip Alarm Functions 44
8.3 Trip Alarm Codes 44
8.4 Troubleshooting Flow Diagrams 45
9 Braking 55
9.1 Introduction 55
9.2 Overhauling Loads 55
9.3 Calculations for Braking Resistors 56
9.4 Minimum Braking Resistor Values 56
9.5 Protection Circuits 57
10 EMC, RFI and Filters 58
10.1 Electromagnetic
Compatibility (EMC) 58
10.2 Single Phase RFI-FP Filter 60
10.3 Three Phase RFI-FP Filter 61
10.4 RF Ferrite Physical Data 62
11 Supplementary Data 62
11.1 Insulation Testing 62
11.2 Table of Cable Sizes and Maximum
Lengths 63
11.3 Table of Heat Losses 64
1
Contents
To Next Page
Loading...