3-10
Figure 3.3 shows the procedure for selecting the desired monitor item.
*
1
The speed monitor may display the output frequency (Hz), set frequency (Hz), load shaft speed (rpm),
line speed (m/min.), and constant rate of feeding time (min.) which can be selected by setting up function
code E48.
*
2
These PID-related information will appear only when the inverter is under the PID control. (Refer to
Section 3.3.)
*
3
This will appear only when timer operation is enabled by setting up function code C21. (Refer to Chapter
5.)
Figure 3.3 Monitor Item Selection Example
To Next Page
Loading...
