14
2. Press the key . The figure on the left of the display (C8) will start blinking.
3. Press the key to increase the value or the key to decrease it. The led is
now blinking, showing that the value is under modification.
4. Press the key
until the middle figure of the display (C8) starts blinking.
5. Press the key to increase the value or the key to decrease it.
6. Press the key until the figure on the right of the display (C8) starts blinking.
7. Press the key to increase the value or the key to decrease it.
8. Press several times the key until you come back to mode L (residual time to end the
test). Confirming the data storing, the led will stop blinking.
SIEVING MODE
T
he sieving procedure can be selected either in intermittent or continuous way.
INTERMITTENT SIEVING
Every pause lasts 2 seconds (OFF time).
The vibration period between two pauses (ON time) can be varied by setting on the display a value
from 1 to 999 seconds:
1. Press several times the key until on the numeric display (C8) appears letter C
(showing present sieving mode or possibility to select it).
2. Press the key . The figure on the numeric display (C8) shall blink.
3. Press the key to increase the value or the key to decrease it. The led
is now blinking, showing that the value is under modification.
To Next Page
Loading...