Use only specified wire rope for lifting. Retain at least three full wraps of wire rope on the winch
drum at all times.
WIRE ROPE
Before extending the boom, always pay out the wire rope. Failure to do so may overstress the
wire rope and cause a two block condition.
Daily Safety Inspection
Use the Crane Log, IMT Manual No. 99900686, the inspection checklist in the reference section
of this manual, or the following list when inspecting your unit at start-up and during operation:
1 Vehicle - Check oil level, battery, lights, brakes, and tires for inflation, pressure, cuts, and
loose or missing wheel lugs.
2 Safety Accessories - Check for proper function, oil levels, leaks and malfunctions.
3 Hydraulic Oil Reservoir - Check for proper oil level, leaks and blockages.
4 Weldments - Check visually for damage, especially cracks or breaks in welds.
5 Cylinders - Check for leakage and scored rods.
6 Fasteners - Check pins, sheaves, nuts and bolts for breakage, excessive wear and
tightness.
7 Crane Hooks - Check for the presence of a safety catch, twists, cracks, or damage.
8 Ropes & Slings - Check for frayed edges, broken strands, kinks, flat spots, and end
attachments.
9 Covers and Guards - Check for missing or improperly maintained covers and guards.
10 Operation Placards and Safety Decals - Check for illegible or missing decals and placards.
Refer to the decal section of this manual for more information on the required decals.
Replace or repair any items as needed prior to equipment operation.
To Next Page
Loading...
Need help?
General
