IN-COMMAND JRVCS2 User Manual

JRVCS2
30
5. Enter admin passcode to proceed.**
6. Select “Tanks” to set resistor reference value for every tank.
5.1 Make Selection.
* The system should be calibrated by the manufacturer and only need to be accessed for troubleshooting.
** The Engineering and Admin Passcode is used by the manufacturer for programming and troubleshooting purposes.
Should there be a calibration issue, call ASA Electronics Technical Support at 1-877-845-8750 or email them at info@asaelectronics.com.

IN-COMMAND JRVCS2 Specifications

General

Brand	IN-COMMAND
Model	JRVCS2
Category	Control Systems
Language	English