What to do if IN-COMMAND Control Systems DC shows 0V and no functions activate?
If the IN-COMMAND Control Systems DC shows 0V and no functions activate, first, check that the 4-pin RV-C cable is connected to the back of the DC and to the BCM. Then, check the RV-C cable for shorts and loose pins in the connection.
How to troubleshoot IN-COMMAND NCSP35CM Display Commander if it will not power on?
If the IN-COMMAND Control Systems Display Commander (DC) will not power on or has no front panel operation, check for +12VDC on the positive (+) input and ground on the negative (-) input on the back of the DC. Also, check the fuse in the Distribution Panel and try cycling power with the power button.
What to do if IN-COMMAND NCSP35CM DC screen flashing on and off after installation?
If the IN-COMMAND Control Systems DC screen is flashing on and off after installation, disconnect the power wires from the back of the DC and shut off all power to the DC and BCM. Reconnect the power wires to the DC and return power to the DC and BCM. Finally, press the Reset button on the BCM.
What to check if no power to IN-COMMAND NCSP35CM Control Systems Body Control Module (BCM)?
If there is no power to the IN-COMMAND Control Systems Body Control Module (BCM), check for +12VDC on pin 42 and ground on pin 39. Also, check the fuse in the Distribution Panel.
How to fix IN-COMMAND NCSP35CM relay that is not activating?
Replace the relay with one from an unused circuit. See the label on the BCM cover for relay identification.
General| Brand | IN-COMMAND |
|---|---|
| Model | NCSP35CM |
| Category | Control Systems |
| Language | English |
Safety warning against operating the system while the vehicle is in motion.
System is intended for users aged 18 and older only.
Emphasizes the need for a clear view of moving parts during operation.
Warning against operating the system under the influence of substances.
Caution to protect the equipment from rain or moisture.
Advises using only approved accessories for safety and performance.
Lists key features of the iN-Command system.
Lists important safety and usage precautions.
Details the components included in the package.
Lists necessary tools and materials for installation.
Instructions for safely disconnecting the battery before installation.
Guidance on choosing an appropriate location for mounting.
Steps and diagram for mounting the Display Commander.
Wiring diagram and pinout for the Body Control Module.
Configure the delay before passcode protection activates.
Instructions for changing the existing passcode.
Steps to remove the current passcode.
Guide on editing text labels for functions on the DC.
Instructions for reordering items in scrollable lists.
How to add and manage slide functions in the system.
How to add and manage awning functions in the system.
How to reset all system settings to default.
How to customize system notifications for various parameters.
Step-by-step guide to pair an iOS device with the Display Commander.
Step-by-step guide to pair an Android device with the Display Commander.
How to load the RV floor plan configuration onto the DC.
Controls for vent fans, including speed and operation.
How to operate the fan without AC.
Steps to set temperature and fan speed for AC cooling.
Instructions for operating the HVAC in heating mode.
How the HVAC system automatically switches modes.
How to set temperature and operating times for HVAC.
How to reset the floor plan to default or OEM settings.
How to customize the floor plan settings.
Detailed options for customizing floor plan settings.
Detailed options for customizing floor plan settings.
How to calibrate system settings like App Data, Hour Meter, and Tanks.
Process for deleting current App data and floor plan settings.
Procedure to set or adjust the generator hour meter.
To Next Page
