EasyManua.ls Logo

Indel Webasto Compact Classic - Unit Start-up and Operation; Electrical Mains Power Supply Connection

Default Icon
41 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7.6 Start-up
Test the operaon of the unit by turning the thermostat knob in a clockwise
direcon. The compressor must start up within 30 seconds, aer which you will hear
a slight hum. The fan will also start up a few minutes aer the evaporator starts to
freeze. You can adjust the temperature considering that the lowest temperature can
be obtained by rotang the knob clockwise and the highest temperature, conversely,
by bringing the knob to the posion closest to that of the circuit breaker. To stop
unit operaon, fully rotate the same knob in a counter clockwise direcon. The
thermostat opposes some resistance which must be countered.
7.7 Electrical mains power supply
Connecon to the electrical mains can be made for Compact Classic operaon.
When using a baery charger, always connect it to the baery and never to the
refrigerator's electronic unit. An even beer soluon is installing a "Power Pack"
transformer, an oponal accessory, which switches automacally from baery power
to electrical power when the laer is connected.
When using a AC/DC (115/230 Vac and 12-24 Vdc) control unit, make sure that:
- the connecon is double insulated as in the gure
Figure 11: Detail of double insulated connecon
- the earthing cable is longer than the other cables to ensure it will the last to
disconnect if pulled.
- the earthing cable is connected via a screw on the metal structure/s of the
compressor as indicated in the gure in the suitable allocaon
User Manual
75