Procedure
1.
Example: G200.2 Work area door 03 1
The front cover is also the front pane/design pane (a). It is screwed to the work
area door. Loosen the screws (M6) along the contour on both sides and remove
(Fig. 03 1). Remove front cover/pane, carefully place aside and secure against
tipping over.
2.
Example: G200.2 Work area door 06
Cut the silicone sealing (s) on the inside of the window pane (see Fig._06) with
a suitable knife.
Maintenance Summary - 8 Years
145
Maintenance Instructions
G200.3 G220.3
DIE248EN - 15.08.2022
To Next Page
