AM125 - Check coolant
Orientation
For add-on equipment that cannot be cooled conventionally with cooling lubricants
or hydraulic fluid due to high temperature development, separate cooling is provided
in an independent cooling circuit. The coolant used here must be checked
continuously for its condition like other coolants.
Cooling diagram of MS
1
Control cabinet cooling
2 “Cold” circuit
3 “Warm” circuit
4 Heat exchanger machine
5 Heat exchanger cooling lubricant
6 Cooling water distribution unit
The system comprises a cooling circuit on the machine side and either
1. a water recooler located next to the machine or
2. an external cooling circuit provided by the machine operator/owner.
Due to different requirements and/or specifications of the respective
manufacturers, be sure to review the respective manufacturer's
documentation!
For all work in connection with operating materials, the information in
the data sheets of the operating fluid manufacturers and the
information in the documents Notes on Operating Materials and
Transport, Installation, Commissioning must be observed.
Requirement
When using a water recooler, be sure to follow the manufacturer’s
instructions.
Maintenance Summary - Care activities
32
Maintenance Instructions
MS40-8
DIM078EN - 02.06.2020
To Next Page
Loading...
