CM270 - Check MS guard switch/interlock
Carrying out the maintenance activities described below requires
special knowledge. For this reason, these maintenance activities
must only be carried out by staff that has received adequate training
by the machine manufacturer!
Orientation
Different safety hood interlocks are fitted to the machine, depending on the
equipment and machine type. These switches must be checked regularly.
Requirement
The following materials and equipment is required:
- servicing, testing and maintenance schedules/logs of the customer
- Various sizes of jaw and box wrenches, and Allen keys
Procedure
1.
Warning
By-passing or overriding or use of defective safety
devices
Danger to life and limb
Regular check and maintenance of safety devices
Check front work area door for “Closed” position.
2. Check front work area doors for “Open” position.
3. Check rear work area door for “Closed” position.
4. Check rear work area door for “Open” position.
5. Check the seals of the work area doors.
6. Check the general condition of the work area door, e.g., for damage.
7. Log the checks in the service, inspection and maintenance schedules/logs of
the customer/INDEX.
Maintenance Summary - 2.000 Operating hours
64
Maintenance Instructions
MS40-8
DIM078EN - 02.06.2020
To Next Page
Loading...
