Using Keyrah V3
3.6 Keyboard Mapping
Generally for all keyboards one of four keymaps can be selected. This is done by using the “power”
switch and the EN/DE jumper.
The “power” switch switches between a “normal” and a “emulator” keymap:
• When the switch is in “off” (down) position, a key mapping is used which is optimized for
regular PC work. In this mode additional extra layers via a “Fn” and/or right shift key are
available.
• When the switch is in “on” (up) position, a key mapping is used which is optimized for
being used with an emulator. In particular no extra virtual layers are applied. Unless there is
a good reason not to, this setting will also stick to the same mapping that Keyrah V2 used in
emulator mode.
The EN/DE jumper switches between what kind of keyboard layout the Keyrah pretends to be
(english or german). This is for the most part relevant for the CBM keyboards.
• When the Jumper is closed the german keymap is selected
• When the Jumper is open the english keymap is selected.
14
To Next Page
Loading...
