Infasecure CS4513 - Page 19

18
ISOFIX Compatible Restraint
Infant Seat
Step 5:
Step 6:
Installing using flexible ISOFIX Lower Anchorage Connectors (LAC)
Figure 4
Top Tether
Strap Guide
Top Tether
Strap
Attachment Clip
Flexible LAC strap
Figure 5
Figure 6
Locate the adjuster at the side of the restraint and
secure using the Top Tether Strap Guide (refer
Figure 4 & 5).
Hook the attachment clip to the upper anchor tting
(refer Figure 6).
Note: If no upper anchorage tting is available refer
to Pages 54 & 55.
IMPORTANT
!
The purchaser should check the
measurements between the front of the
seat back of the rear seat and all front
seats in the car in which the child restraint
is intended to be used, to ensure that the
space is sufcient.
Care and attention should be given to
sufcient ventilation and shading of the
baby.
Always secure the loose end of the top
tether strap to prevent it hanging out of
the car or being accessible by the child.
IMPORTANT
!
For removal of LAC straps from vehicle
‘PULL’ the red strap to detach from
anchorage point and store in the
compartment beneath the seat.
Top Tether
Strap
Top Tether
Strap Guide