Pull to
Lengthen
Pull to Tighten
Figure 9Figure 5
Figure 9Figure 4
Figure 6
Storage
Pocket
Note: If no upper anchorage tting is available refer to
Pages 54 & 55.
Hook the attachment clip to the anchor tting. Ensure
there are no twists in the top tether strap (refer to
Figure 4).
Pull to tighten to remove all the slack, from the upper
anchorage strap. Do not overtighten as this could
cause the restraint to lift off the vehicle seat (refer to
Figure 5).
Store any excess webbing, from the top tether strap,
in the storage pocket provided on the restraint (refer
to Figure 6).
IMPORTANT
!
For removal of LAC straps from vehicle
‘PULL’ the red strap to detach from
anchorage point and store in the
compartment beneath the seat.
CAUTION: CHILDREN CAN BE
INJURED OR RESTRAINTS AND
TOP TETHER STRAP DAMAGED
BY UNSECURED CARGO IN A
COLLISION. SECURE OR
REMOVE HAZARDOUS CARGO
BEFORE USING THIS CHILD
RESTRAINT.
IMPORTANT
!
Always secure the loose end of the top
tether strap to prevent it hanging out of
the car or being accessible by the child.
To Next Page
Loading...
