Inficon BPG400 - Making a Devicenet Interface Cable (BPG400-SD)

24 tina03e1 (0206) BPG400 v1.om

Plug the sensor connector into
the gauge and secure it with the
locking screws.
 Connect the other end of the sensor cable to the connector of the instru-
ment or gauge controller you are using.
The gauge can now be operated via analog and RS232C interface.
For operating BPG400-SD via DeviceNet, an interface cable conforming to the
DeviceNet standard is required.
If no such cable is available, make one according to the following indications.
A shielded special 5 conductor cable conforming to the DeviceNet standard has to
be used (
® & [4], [6]).
 Make the DeviceNet cable according to the following indications.
3
1
42
5
Micro-Style, 5 pins,
(DeviceNet)
female, soldering side
Pin Function (BPG400-SD)
1 Drain
2 Supply +24 VDC (DeviceNet) interface only
3 Supply common GND (DeviceNet interface only)
4 CAN_H
5 CAN_L
3.2.2.2 Making a DeviceNet
Interface Cable
(BPG400-SD)
Cable type
Procedure