Inficon CU1000

INFICON Operation CU1000 | 6
CU1000-operating-instructions-jina54en1-06-(1901) 13 / 36
1 Keyboard lock 2 Communication status 3 Data recording
4 Operator 5 Zero 6 Message
7 Tracer gas 8 Operation mode 9 Leak rate with peak hold function
10 Graphic representation of the leak
rate and the peak hold function
11 Time axis 12 Foreline pressure
13 Button "Favorite 2" 14 Button "Favorite 1" 15 Menu
16 Value axis 17 Value axis
1 - Keyboard lock
The control unit is locked or unlocked by pressing and holding the icon for the
keyboard lock.
2 - Icon for the communication status
• Icon connected: The device communicates with the mass spectrometer module.
• Icon disconnected: The device does not communicate with the mass spectrometer
module.
Establish communication:
1
Reset control unit.
2
Checking the status of the mass spectrometer module.
3
Check cable connection.
3 - Icon for the data recording
The measurement is recorded.
4 - Ser
The registered operator is shown abbreviated.
Display Meaning
Ope Operator
Sup Supervisor
Int Integrator
Ser Service
For more information, see Chapter 6.2.2., Page 20.
5 - Zero
Background suppression is active.