Inficon CU1000

INFICON Operation CU1000 | 6
CU1000-operating-instructions-jina54en1-06-(1901) 21 / 36
6.3.2.1 Logging out the operator
The operator activates access level "Viewer" to log out. "Access Ctrl > Viewer"
6.3.3 Functions
6.3.3.1 Resetting the settings
Mass spectrometer
module
The settings of the mass spectrometer module can be reset to factory settings.
Control unit Functions > Data > Parameters > Reset >
MSB settings
Access controls
The authorization for changing parameters can be reset to factory setting.
Control unit Functions > Data > Parameters > Reset >
Param. access control
Control unit
The control unit settings can be reset to factory settings.
Control unit Functions > Data > Parameters > Reset >
Control unit settings
6.3.3.2 Recording data
The data is saved as a TXT file. Each TXT file contains the following information:
• Date created
• Software version
• Serial number
• Start time
• Time stamp (measurement indicates offset in seconds in relation to start time)
• File name
• Time stamp (offset in seconds in relation to start time)
• Leak rate (expressed in selected unit)
• Pressure p1 (expressed in selected unit)
• Device status
Switching on/off
Switching data recording on/off
• Off
• On
Control unit Functions > Data > Recorder > Settings >
Data recording
Record interval
Time interval between data recordings
• 100 ms, 200 ms, 500 ms, 1 s, 2 s, 5 s