To Next PageTo Next Page
Need help?Do you have a question about the Inficon Protec P3000 and is the answer not in the manual?
General| Brand | Inficon |
|---|---|
| Model | Protec P3000 |
| Category | Controller |
| Language | English |
Overview of the Protec P3000 leak detector and its intended applications, including mandatory sniffer probe use.
Details on the four different configurations of the Protec P3000 leak detector available to users.
Key physical and electrical specifications of the Protec P3000, including leak rates and measurement ranges.
Information and guidelines for returning equipment to INFICON for service or repair.
Instructions for unpacking the Protec P3000 and a list of all supplied components and accessories.
Explanation of symbols, terms, and conventions used within the technical handbook.
Step-by-step instructions for setting up, connecting, and installing the Protec P3000 leak detector.
Overview of the Protec P3000's main functions and its principal subassemblies.
Detailed explanation of key components like the backing pump and Wise Technology sensor.
Description of the main unit display, probe display, and the PRO-Check reference leak interface.
Steps for powering on the Protec P3000 and initiating the automatic start-up sequence.
Guide to the buttons and functions available on the main unit's display for setup and operation.
Explanation of controls and display features on the sniffer probe handle for remote operation.
Details on the Standard Operation Mode and the I•Guide Operating Mode for leak detection.
Instructions for internal, external, and proof function calibrations to ensure accuracy.
Procedures for putting the unit into standby, shutting it down, and storing it for availability.
Diagram and explanation of the main menu structure and navigation keys.
Information on accessing the password-protected service menu, intended for trained personnel.
Setting up gas parameters, trigger levels, and selecting gas equivalents for measurements.
Configuration options for vacuum, access, audio functions, display, and miscellaneous settings.
Configuration of control location, recorder outputs, PLC inputs, RS232 protocol, and baud rate.
Accessing general information, error lists, calibration history, and maintenance data.
Viewing historical data, error lists, calibration history, and maintenance status.
Explanation of error and warning messages, their possible reasons, and recommendations for resolution.
Details on I/O port pin assignments for control inputs, outputs, and relay configurations.
Configuration and usage of the RS232 interface for external control and data export.
Overview of routine maintenance tasks, required tools, and repair levels.
Instructions for checking and replacing the main unit's air filter.
Procedures for replacing various filters within the sniffer line, including capillary and tip filters.
Step-by-step guide for replacing the gas reservoir of the PRO-Check reference leak.
List of approximately 100 gas equivalents relevant to the refrigerating industry stored in the device.
Statement of conformity with relevant EU directives and applied harmonized standards.
Alphabetical index of terms, topics, and their corresponding page numbers for quick reference.
