General Information 13
Electrical Data
Other data
1.2 Support by INFICON
INFICON Service
If equipment is returned to INFICON or an authorised INFICON representative indi-
cate whether the equipment is free of substances damaging to health or whether it is
contaminated. If it is contaminated also indicate the nature of the hazard. INFICON
must return any equipment without a Declaration of Contamination to the sender’s
address. You will find an appropriate form below.
General
We reserve the right to alter the design or any data given in this handbook.
The illustrations are not binding.
Gas flow through the capillary
For Protec P3000 225 - 375 sccm*
For Protec P3000XL in
HIGH FLOW mode 2660 - 3500 sccm*
Time until ready for operation approx. 3 min
* Measured at 1 atm (1013 mbar) at sea altitude. Actual flow may vary with increased
altitude and low atmospheric pressure.
Mains voltages and mains frequencies 100 - 120 V, 50 / 60 Hz
(fixed) 207 - 236 V, 50 / 60 Hz
Power consumption 200 VA
Type of protection IP 20
Overvoltage category II
Noise level < 54 dBA
Dimensions (w x h x d) in mm 610 x 370 x 265
Weight 27 kg
Permissible ambient temperature
(during operation)
10 °C to 45 °C
Permissible storage temperature -40 °C to 60 °C
Relative humidity max. 80% for temperature up to +31°C,
decreasing linearly to 50% at +40°C
Contamination level 2
Max. altitude above sea level 2000m
To Next Page
Loading...
Need help?
General
