General Information 15
1.3 Unpacking
Unpack the Protec P3000 leak detector immediately after it has been received even
if it is to be put into operation at some later date. Examine the shipping container for
any external damage. Completely remove all packaging materials.
Notice Retain the shipping container and the packaging materials in the event of
possible complaints concerning any damages.
Check if the Protec P3000 leak detector is complete (see Section1.3.1) and carefully
subject it to a visual inspection. If any damage is discovered please immediately
inform the forwarding agent and the insurers. If it is required to exchange the
damaged part please contact our orders department.
1.3.1 Supplied Equipment
The Protec P3000 leak detector is ready for operation. Before installation please
read Section 1.5. Included with the leak detector are the following items:
• Protec P3000 (main unit)
• Mains cord
• Set of fuses (3 x 10 pcs.)
• Spare air filter
• 8 mm hexagonal wrench
• Documentation
– Operating Instructions Protec P3000 (kina26en1)
– Interface Description Protec P3000 (kins26en1)
Notice The SL3000 and SL3000XL sniffer lines are available in different
configurations and need to be ordered separately in the desired length. The
SL3000(XL) sniffer line is not part of the Protec P3000 shipment. (see
Section 1.3.2 Accessories)
Notice The PRO-Check reference leak is an accessory (see Section 1.3.2
Accessories) and needs to be ordered seperately
Notice For the RC versions the display unit and the connecting cable are not part
of the standard Protec P3000 shipment and need to be ordered separately
(see Section 1.3.2)
To Next Page
Loading...
Need help?
General
