98 Maintenance
7.2 Exchanging the air filter
To exchange the air filter, place the Protec P3000 on its front-side or position it on
the edge of a sturdy bench. If placing it on the edge of a bench, please pay attention
to its center of gravity. If placing it on its front-side, please remove the sniffer line and
the built-in PRO-Check first.
Notice To prevent scratching of the front-cover, it is recommended to use a soft
base.
1 The fastener for the air filter is on the bottom of the Protec P3000.
2 Screw out the fastener screw.
3 Extract the air filter.
The air filter should be checked for contamination at least every 6 months
and should be definitely exchanged after 2 years.
Before exchanging the filter the Protec P3000 must be disconnected from
power.
Fig. 69 Fastener for the air filter on the bottom of the leak detector
To Next Page
Loading...
Need help?
General
